According to industrial requirements, the bending machine can bend some very hard and thin plates to make them in a bent state, with good bending effect and no rebound. And it is suitable for almost all types of thin plates. It will not break the plate while maintaining performance, and it is safe to use. However, from their structural analysis, the operation of the equipment is very particular, so how does the user operate and use it?

The first is to turn on the power, turn on the key switch on the control panel, and then press the oil pump to start, so that you can hear the sound of the oil pump turning. The machine does not work at this time.

Stroke adjustment, the use of the bending machine must pay attention to adjusting the stroke, and be sure to test the car before bending. When the upper die goes down to the bottom, there must be a gap of plate thickness. Otherwise, it will cause damage to the mold and the machine. The adjustment of the stroke also has electric quick adjustment and manual gastric adjustment.

For the selection of the bending notch, it is generally necessary to select a notch with a width of 8 times the thickness of the plate. For bending 4mm sheet, you need to choose a notch of about 32.

The rear gauge adjustment generally has electric quick adjustment and manual fine adjustment, the method is the same as that of the shearing machine.

Step on the foot switch to start bending, you can release it at any time, when you release the foot, the bending machine stops and continues to descend.