Four-roller plate rolling machine power supply turn on concise steps

1. Inspection and preparation

Open the cabinet wiring: After cutting off the external power supply, open the electrical cabinet, access the three-phase four-wire main power line according to the instructions (pay attention to the phase sequence), and connect the operating system power line to ensure that the interface corresponds to the correct.

Add hydraulic oil: fill the oil tank with hydraulic oil of the specified type and observe the oil level to the standard range.

2.Startup and test

Energize and test the machine: insert the key and rotate it to the “ON” position, the equipment enters the standby state; press the start button of the oil pump and observe whether the value of the hydraulic pressure gauge is normal. 4. check the steering: immediately after startup, connect the power cable of the operating system to ensure that the interface corresponds correctly.

Check the steering: stop immediately after starting, start again to observe the motor steering (usually clockwise). If the direction is wrong, adjust the phase sequence of power supply after power failure.

3.Safety Tips

Operation of the whole need to disconnect the power wiring, wiring to confirm the firm.

Hydraulic oil type, oil volume and motor steering must be carried out in accordance with the instructions.

Non-professionals do not adjust their own lines, contact the technical staff to deal with abnormalities.

Summarize: Follow the process of “wiring → refueling → test → calibration steering”, operate strictly according to the manual to ensure safe and efficient start-up equipment.